Categories

Contact Us

Add:Zhangmingqiao Qianzhou Huishan, Wuxi, Jiangsu, China

Tel:+86-510-68783338

Mobile:+8613914103158

Fax:+86-510-68006664

E-mail: weitepress@aliyun.com

News

Home > News > Content
Extrusion Press Specific Species
Jul 11, 2017

Extrusion Press Specific species

Extruder specific types, and the site products and keywords related to the aluminum and copper profile extruder are two, but the following, mainly to introduce one of them, because the article is limited. Therefore, at this specific request, will be for one of the copper profile extruder, to start and carry out its learning work, but also hope that we can gain some, rather than waste such a good learning opportunities.

 1. Copper profile extruder, if the hydraulic system failure problem, then, whether there will be serious consequences or impact?

    Copper Extrusion Machine This kind of extruder, its hydraulic system, if there is a problem of failure, then, if not dealt with in time, it will cause serious consequences, or have a great impact, for example, so that the hopper down Slow down, and even make the machine can not work and use. So, we should pay attention, can not be taken lightly.

 2. Is there an extruder that can and can squeeze the copper profile and squeeze the aluminum profile? In addition, the extruder squeeze too fast, what is the reason?

    There are extruders that can squeeze copper profiles and squeeze aluminum profiles. We call these two extruders a copper-aluminum extruder, which has a variety of uses. The extruder extrusion speed too fast, the main reason is because the plunger pump flow is too small, and has nothing to do with the valve. Moreover, this also applies to copper profile extruders.

  3. With copper profile extruder production profiles, then, in the type of profiles, whether it is a single?

    With the copper profile extruder production profiles, then, in the type of profiles, it is not a single, so, on this issue, it can be said that the answer is not. Because the profiles can be both hollow and solid. Moreover, the hollow profile, which refers to the cross section of the profile has one or more closed through-hole profiles. Solid profile, which is not closed through the hole.

 1. Extrusion machine in the aluminum extrusion machine, its work pressure, whether it is for working pressure?

    Extrusion machine in the aluminum extrusion machine, the pressure of its work, not only the work pressure of this one, there is a system pressure this one, so in this issue, the answer is not. Moreover, for system pressure, its size can be adjusted by means of relief valves and pressure regulators. And its branch module of the oil valve, to adjust it, you can adjust the work unit of oil and pressure.

 2. Is the extruder die size, whether it is fixed? In addition, melt spinning machine, which is generally used as an extruder?

    Extruder mold size, in general, it is fixed. Moreover, for the aluminum extrusion machine, the mold, there is a standard shape of the mold table, we can refer to and in order to get accurate results. On the melt spinning machine, it is an extruder using a screw extruder. Its important parts are for the screw, and it can be divided into three sections of the feed section, the compression section and the metering section.

3. In the extruder, magnesium and magnesium alloy extrusion process and aluminum extrusion process, is the same?

   In the extruder, magnesium and magnesium alloy extrusion process and aluminum alloy extrusion process should be roughly the same, but there are some differences, mainly in the heating mode, extrusion temperature, extrusion speed, mold Size and tension pull correction of these five aspects, as for its detailed description, after a chance to come again.